Gary If you can find a round object ~ rod or dowel ~ that is the same O'D' as the I'D' of the Chase, you can fill the hole with grease & then drive the rod or dowel or whatever into the whole & with fingers crossed the chase will be pushed out by the hydraulic pressure. Good Luck! ORR ~ DeanB
On 11 Jan , 2012, at 7:48 PM, Gary Meier wrote: > When i pulled the engine due to a howl when the clutch was > disengaged I found the pilot bearing in dust with a few very small > pieces. Now I.m faced with removal of the outer race. There's not > enough of a lip for a puller to catch. Any BTDT/Suggestions/Advice > on how to remove the outer race on the pilot bearing will be greatly > appreciated. > Gary Meier |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.