Jim, i have some lock info here http://shufti.wordpress.com/2010/03/05/lock-info/
door locks, but might be useful in your quest. But Bentley, 94.2 is good place to start fig 7 on 94.4 shows where to drill to remove cylinder alistair
On 2012-02-01, at 11:28 AM, Jim Felder wrote: > Last week I wrote that I had a starting problem with the key sometimes not > starting the starter motor. I had a switch, and replaced it, but it still > happens (once in three days—not too bad but not fixed). > > I went into my stash of Vanagon parts and found the mechanical lock from a > 1990. > > Should I take the cylinder set out of my old one and put it in my new one, > or is it likely that the cylinder and brass tumblers are part of the > problem? > > I have an assortment of brand new tumblers. Should I match them up until > the "old" key works with the "new" lock? > > How do I get the tumbler out of the lock mechanism? > > Thanks, > > Jim |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.