You could easily only do one side, but it's better to do both sides, if for no other reason than to get dirty only once. In other words, get it over with. The last time they were done, if ever, they were likely both repacked or replaced. It's recommended to discard the allen head bolts and replace with the 'Triple Square,' as these have heads that are difficult to strip. The usual vendors stock these. Also, go to VanCafe and search for their CV tutorial. This is a very good article, with clear instructions. Easy, but dirty job........have fun! Miguel
On Sat, Feb 18, 2012 at 6:55 PM, Jason <uberhare@gmail.com> wrote: > 1) only use GKN oe replacement joints avoid those aftermarket complete > axles like the plauge. > > 2) if the otherside is in unknown condition disassemble, clean, inspect, > repack or replace as required. > > Jason > On 2012-02-18 8:38 PM, "Kendra Calhoun" <kendracalhoun@gmail.com> wrote: > > > > When one is replacing driver side rear axle, does the passenger side have > > to be replaced as well? Given how old or rusty the other side could be, > > does it make sense to just replace one? The van is a 1982 VW Vanagon. > > I appreciate everything you can do for me. > > Thank you! > > Kendra > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.