I don't think the injector reading is a problem. I have seen this higher than Bentley spec reading most of the time when testing and the injectors are fine. Have you tried running with the oxygen sensor unplugged yet? On 3/8/2012 8:40 AM, Bryan Feddish wrote: > OK, I’m home today to work on this. I followed Ken’s directions and I’ve checked the impedance at the temp sensor and I’ve done all the tests on 24.20 of the Bently. All of the impedances check out, including the temp I and II matching ohms, except both fuel injector connections are reading 21 ohms instead of 16 like the Bently says. > > First question, is the impedance at the injectors a problem and if so what do I do to fix it? Second, is there anything else I should check before I start the engine for the day? > > Thanks, > Bryan > -- Thanks, Ken Wilford John 3:16 www.vanagain.com Phone: 856-327-4936 Fax: 856-327-2242 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.