After I replaced a relatively new inside rear wheel bearing the other day, I got to thinking about how the grease is supposed to stay in that bearing. It is an open ball bearing (17 mm id, 35 mm od, 17 mm thick ,NSK6207 C3 or KOYO 6207R) and when you are installing your supposed to pack the bearing itself with grease and also add grease in the housing (where the spacer is). I don't understand how adding grease to the housing helps, I can't see how grease there is supposed to get into the bearing. So I wonder if using a sealed version of the bearing would be better? They are available, KOYO 6207 2RS for example. Am I missing something in my understanding of ball bearings in this application? alistair |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.