Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2012, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 21 Apr 2012 12:45:39 -0700
Reply-To:     Karl Wolz <wolzphoto@Q.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@Q.COM>
Subject:      Re: Engine cut out.
Comments: To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
In-Reply-To:  <4F930549.3070403@turbovans.com>
Content-Type: text/plain; charset=utf-8

Couple times I've crested. Hill in third and nodded off on upshifting. Pretty easy to hit governor range if you have craniorectalitis.

Karl Wolz Sent from my electronic umbilicus

On Apr 21, 2012, at 12:06 PM, Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM> wrote:

> My thought too .. > you'd really have to wind the pee out of it to activate the rpm cut out > in any gear. > I have seen them be very happy to rev - a 1.9 wbxr with manual trans , > but you're not that brutal on it are you ? > > > On 4/21/2012 5:42 AM, Bryan Feddish wrote: >> I don’t think I'm reving that high. I know I don’t have a tach but it >> really >> feels like it's cutting out sooner than it should. >> >> Thanks, >> Bryan >> >> -----Original Message----- >> From: Dennis Haynes >> Sent: Saturday, April 21, 2012 8:30 AM >> To: 'Bryan Feddish' ; vanagon@GERRY.VANAGON.COM >> Subject: RE: Engine cut out. >> >> The engine should cut out ~5,200 to 5,400 rpms and you can easily >> reach that >> in 2nd gear. This is a great exercise to pound out those main bearings >> and >> the case around them. >> >> Dennis >> >> -----Original Message----- >> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On >> Behalf Of >> Bryan Feddish >> Sent: Saturday, April 21, 2012 7:28 AM >> To: vanagon@GERRY.VANAGON.COM >> Subject: Engine cut out. >> >> The van has been running very well the last few months after all that >> tinkering. City gas mileage is still not where I’d like it but I ‘m >> going >> to check the highway mileage next week. Anyway, I have this persistent >> problem. If I accelerate to really high RPMS, like in 2nd gear, I get >> to a >> point where the engine just cuts out like a switch. This is 100% >> reproducible as it does it all the time and the engine runs fine >> otherwise. >> I don’t have a tach so I could not tell you how high the RPMs are. I >> do have >> a big clock so I could tell you what time it was, except in the winter. >> >> Any suggestions? I have an ‘83.5 WC. >> >> Thanks, >> Bryan >>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.