I'm interested in hangining my exhaust in an all-bolts configuration on the rebuilt 2.1 I have going into my 1.9 van. I plan to use a4 stainless 8x30 bolts. (My reasons are: it seems both studs and bolts have benefits, but they are maximized running all-studs or all-bolts. E.g., with all-studs, none of the holes have thread-wear, with all-bolts, you can do a head gasket without removing exhaust. All-studs are not an option for me since the 1.9 water pump is in the way of removing the headers when using all-studs.) My plan is to remove the studs was just to tighten two nuts against each other on each stud and use that to twist it off. I'm guessing that this should be easy since the heads (and studs) are brand new. Do I need to use a stud puller instead? Or should they come out easy with the double-nut? Thanks, Wes |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.