Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2012, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Wed, 2 May 2012 17:41:40 -0400
Reply-To:   Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:   Re: Another Monster Battery Option For Stock Locations-Charging!
Comments:   To: Derek Drew <derekdrew@DEREKMAIL.COM>
Content-Type:   text/plain; charset="US-ASCII"

One of the advantages of AGM type batteries is their extremely good "charge acceptance". The work very well in float charge applications. While multi stage chargers seem like a necessity they are really only needed on a periodic basis. The work on voltage/current sensing and the characteristic of batteries during the charging process. As such in order for them to really work the battery-charging circuit cannot be connected to any load, especially and load that varies. Also, for AGM batteries many chargers will go to a 16.5 or higher peak. Say goodbye to many light bulbs. Chargers that are designed-approved for RV use will usually peak out at 14.5 volts and from experience even that is too much for all those little indicator and halogen lamps in my motorhome.

Since AGM batteries tend to be expensive, part of the usage plan has to be to extend their life. It is very important to limit cycles, avoid high temperatures and sudden temperature changes. Most AGM failures are the result of the electrolyte venting-drying out in one or more cells.

Probably the ideal float charge is around 13.8 volts. This will keep things near or below the gassing stage. If you go near or above 14.2-14.5 volts extended drives can cause some positive plate corrosion. Consider that each time you "top off" the battery to this higher voltage you have "cycled" it. For example, you driving and the battery is charged. You stop for an hour or so to rest get some lunch. Your listening to the radio, or using your laptop. Whatever. Yu then go drive again, your smart charger or voltage regulator put that extra umph in after the bulk charge. Yes you have just used one of the 300-500 cycles that AGM may give you. We make it a practice that batteries used for opportunity charge should only go above 80% once a day at most. AGMs tend to last the longest when used between 50-80% stat of charge with periodic maintenance charges.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Derek Drew Sent: Wednesday, May 02, 2012 2:49 AM To: vanagon@GERRY.VANAGON.COM Subject: Re: Another Monster Battery Option For Stock Locations

Group 27 is a great size to go under the driver's seat. That's the size I always used in the past. The only thing is that according to my tests, the Odyssey AGM batteries really are better than regular batteries, and the Sears licensed Odysseys may just be the best batteries in the world of their type. My tests were heavy load tests using load testers and were later coorborated by other tests I found on the Internet. The NC-27 size is normally available in a configuration that fits well under the front driver's seat best if it is a normal vented lead acid battery. But I found that this yields too much problems with battery acid coming out of the NC-27 vents, at least with the lead acid version. The AGM version of the NC-27 is less desirable because it sticks up a little higher in the key area where it might hit the driver's seat swivel so I avoided that. If the NC-27 AGM Odyssey has the same amount of amp hours and reserve capacity as the PM-1 battery I used, in an AGM version, then I wouldn't be surprised if the NC-27 would be an easier fit and preferable to the PM-1 battery I used. But that's a lot of ifs. I might have got stuck because I did not find a quality AGM version of the NC-27 in a deep cycle design. I did not want a lead acid traditional venting version of the NC-27. The PM-1 Sears battery is indeed longer than will fit by dropping the battery into the Vanagon driver's side stock battery tray. In order to drop it in there, you must remove some metal from the area to the right (passenger's side) of the battery tray under the driver's seat. I found that I could remove enough metal, but leave plenty enough there, to fit the PM-1 battery without having to do any welding so this is a metal cutting operation only. I then reinforced the area with bent metal bolted back in, though I doubt the reinforcement was really needed. In order to fit the PM-1, you have to approach the problem by saying that you will widen the battery tray on the passenger side of the tray and have a demonically inspired destructive intent as you hold a sawzall or other cutting tool. After you have widened the battery tray, you will discover that it was a relatively trivial operation, and "major" only in terms of the mental gymnastics required to realize that it is possible. The PM-1 battery lists for the same cost as the Lifeline group 27 batteries that you bought. If the Lifeline NC-27 batteries have the same specs in reserve capacity and amp hours as the Sears PM-1 battery, then I recommend the NC-27 batteries (in an AGM deep cycle version) instead of the PM-1 battery I got. If the PM-1 has better specs in amp hours and reserve capcity, then I'd do the PM-1 again. After checking about 10 times in a detailed manner, I determined that AGM batteries do not need to be in a sealed box, and in fact, are safer without one, especially if you are tuning your charge regulator from the automotive alternator to have the recommended charge voltages as Odyssey recommends for their AGMs. I did not use a sledge hammer. The PM-1 battery protrudes upwards, as does an NC-27 battery, higher than a group 41 battery. But because no special battery box is needed, and rugs with covering wood or metal structuring of the lid may be configured to hide the battery entirely, I felt that on the driver's side the horror of having a battery stick up is mostly psychological before the job is done, because after the job is done you cannot tell, and the westfalia seat swivel can still be made to function as normal by trimming of the metal along the rear edge and/or right rear corner as neccessary in order to allow the swivel to function as normally. I cannot think of any better use of the space behind the driver's seat than to have a battery protrude up there (and then be cosmetically covered) so long as the seat swivel can still function to 90 degrees, so i am a big fan of using either of these two batteries at that location. The one thing you would NOT want to do is to put either of these AGM batteries into a sealed box at that location..... they do have *some* venting even if it is minimal. Instead, just mount them to have air ventiliation, and then make sure that the voltage regulator is doing what it is supposed to do. In this case, there will not be sufficient hydrogen buildup inside the vehcile to be material to humans and their stuff, yet the small amount of hydrogen buildup that does occurr will have someplace to go rather than be trapped in a sealed box where it could turn malevalent. I advocate the use of AGM batteries for Westfalia, so custom tuning of any 3-stage regulator to AGM charging specs would be what the doctor orders unless the 3-stage charger is already set for Odyssey AGM specs. I did not immediately see which charger at <http://www.powerstream.com/lead-acid-charger-Catalog.htm>http://www.powerst ream.com/lead-acid-charger-Catalog.htm was the candidate one for Vanagon/Westfalia use. The idea of a 3-stage charger which would take a 12V input and then output 12 volts 3-stage certainly sounds elegant and interesting so I'd like to see which unit does that. But still, the most efficient method would be to have the voltage regulator do the 3 stage charging at the vehicle alternator rather than have a secondary voltage transformation operation being undertaken. As I said earlier, with respect to battery fitting, what seems like "major mods" before you fit a battery may not seem like "major mods" after the job is done. I don't feel like my method involved major mods now. Among the keys to the operation was grinding all areas to bare metal, and then the use of Eastwood's best and most advanced Extreme Chassis Black chassis primer and paint. I used the very best of the Eastwood's topcoat paint (comes in a paint can and says Epoxy or something similar) rather than the rattle can Extreme Chassis Black spray paint that is listed as almost as good, and I was very pleased with the results and would do that paint again. If your NC-27s have 100 amp hours, Karl, then just check the other specs such as reserve capacity to make sure that these other specs measure up to the PM-1. If they do, then proceed with your NC-27s. If they don't, then you can upgrade yet again if you like to the PM-1. In the discussion above, I used the phrase "NC-27" to mean "group 27." I actually have no idea what the difference between the two phrases may indicate.

At 10:37 PM 5/1/2012, you wrote: >Derek, a couple questions and thoughts: > >This battery is listed as 13" long. Vanagon battery boxes are 12" long. >If it fits with no use of a sledge hammer on the sheetmetal, then Sears >has miss-stated the size number - it would be a group 27. 'Fits' would >mean in would be totally enclosed in the factory box and not protrude. >It appears that it would protrude 2.5", as it is listed at 9.5" tall. > >I have a pair of Lifeline group 27 deep cycle batteries ready to >install in my 'big trip' rig - one of the industry's leading brands, >cost was $270 each (local distributor) and are 100 a/h. These measure >in at 9.25", but can get away with 9" if you remove the bolts in the >posts - has posts with threaded centers. I will be modifying the boxes >to keep them totally covered and away from the seat swivels. My second choice would be Trojan. > >Karl > > > On Tue, 1 May 2012 12:53:11 -0400, Derek Drew > <derekdrew@DEREKMAIL.COM> wrote: > > >I chimed into the thread at > >http://www.thesamba.com/vw/forum/viewtopic.php?p=6013002#6013002 the > >following information. > > > >I am probably among the first to have fit such massively long-lasting > >and powerful batteries into the front two underseat locations so I am > >passing it along that it can be done: > > > >Derek wrote, in the thread: > > > >I installed under the drivers seat the Sears Platinum deep cycle > >PC31, group size 31, similar in size to Odyssey PC 2150. This battery > >has 205 Reserve Capacity, unlike the group size 65 / PC1750 > >batteries, which have more like 135 reserve capacity. The group size > >31 also beats the group size 65 with 100amp hours vs. 68 amp hours > >for the Group 65. The front seat still swivels. The battery sticks up > >higher than it normally would, but is hidden behind the grey rug. In > >order to do this installation, you have to trim the corner of the > >seat swivel (which doesn't look bad) and also trim some metal from > >the area under the driver's seat. Would I do it again? Yes. > > > >The battery under the drivers seat is Sears Item# 02850131000 Model# PM-1.

_______________________________________________ Derek Drew Washington DC / New York derekdrew@derekmail.com Email is best normally but... PHONE: 202-966-7907 (Call the number at left normally) (alt/cell for diligent calling only): 703-408-1532


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.