Date:         Sat, 5 May 2012 22:22:50 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Heater Box, how to remove the flaps?
Comments: To: Alistair Bell <albell@shaw.ca>
In-Reply-To:  <54F15307-A770-4A84-9D61-05F3AF00F265@shaw.ca>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 10:20 PM 5/5/2012, Alistair Bell wrote:
>*if* you choose to replace the foam, use open cell, soft foam. Need
>good compliance with those low closing forces David mentions.

Certainly agree with that part.  But I do recommend replacing foam on
everything except the swinging flaps operated solely by airflow.

d

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.