Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2012, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 16 May 2012 15:19:36 -0700
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: SAmba Ad
Comments: To: Jason <uberhare@GMAIL.COM>
In-Reply-To:  <CAGydU8RyKFRUL1QKat5pS=MGeSvk8kbyjuRmos1jHHUDnO26VA@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

re

I saw another one for sale last week-why not just sell a gallon of gas and a Bic lighter?

In the many hundreds of vanagons I have worked on .. this plastic firewall fitting is not actually 'the problem'

the spot that is really 'the issue' is about 3 inches forward of the firewall fitting, right above the starter .. where a short hose ( about 2 inches long ) that goes from the forward end of the firewall fitting to the plastic fuel line coming from the fuel pump ...the hose is clamped to the plastic line with a crimp type hose clamps.. that is THE SPOT that leaks.

if you look under a van and that crimp type clamp has been replaced with a screw type hose clamp ...it's probably OK.

what I like to do is remove the firewall fitting thing .. and join the hose on the engine ( that goes to the T where you can check fuel pressure, right next to the distributor ) ...joint that hose directly to the plastic fuel line with a ( not american el cheapo # 4 ) good german screw hose clamp, or genuine side-screw band clamp for FI ..... to the plastic line. that works perfectly. I like it going through that space to the right of the bell housing where it's easy to eyeball. As I have said many times.. I see no purpose in running the line through the hole in the metal firewall ...since then you have to proetct with a grommet, that will eventually wear out. one other tiny step ..where the black plastic fuel line is clipped to the bottom of the van's rear floor, above the trans .. take the line out of that clip so it reaches easily to the engine hose. a clamp or two there..and you're good. all gasoline vanagons need this simple upgrade. and it's not the plastic part itself that is the weak part that I have seen so far.

scott

>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.