Neil, you have your lathe running yet? A TB rebuild would be a good project. Bore out TB a tad to remove wear area, make new butterfly, make delrin bushings for shaft. I had a go at it a while back, was fun :) alistair
On 2012-06-12, at 11:31 PM, neil n wrote: > It may simply be a worn throttle shaft > (video: http://www.youtube.com/watch?v=aEGAgefVyQY ) affecting ability to > get an accurate throttle valve switch setting, but the way I have the > switch set now, (hair past specified max of 0.10 mm) I know it closes at > idle every time, engine cold or warm. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.