Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2012, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 9 Jun 2012 16:28:06 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: WBX Digifant Ground Check. No Continuity Between Some Points.
Comments: To: neil n <musomuso@gmail.com>
In-Reply-To:  <CAB2Rwfh+6PmJeQBC9ZnQzAoCr01u9mcnAhci=nhnLVbuv_99iQ@mail.g
              mail.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 03:49 PM 6/9/2012, neil n wrote: >Seems to me I should see continuity.

Continuity is a slippery word when it's printed on the front of a meter (and when it's not) so I tend not to use it.

As a general rule (and it's because I can't remember whether there are any exceptions that I'm waiting on Mr. Bentley) all things labeled ground should in effect be connected to the negative battery terminal. Whether it's ok for there to be half an ohm or whether the maximum is 0.002 ohms, or whether the actual measurement point that's important under the circumstances is pin X on the ECU rather than the negative battery post are matters for individual consideration.

Continuity beepers on DVMs may beep at 150 ohm, or 50. For Van purposes neither one would be even remotely considered a good connection. A test light is better since it puts some load on the connection. But the only way to measure quality of these connections beyond the test-light level is to measure millivolts directly across the connection or set of connections under consideration while they're operating under load. By this you can discover the *functional* quality of the connection under working conditions, using commonly available tools. Because functionally the job is to get as close to 100% of the supply voltage to the load as possible, losing only some acceptable minimum in the supply and return paths. The emphasis is slightly different with senders but the methods are the same.

So a major question with grounds is, what's the voltage between one ground and another (alternator case to engine, say) when things are operating; and is that an acceptable difference.

Now all that being said, and with the caveat of "not quite always" = yes, your meter should certainly show continuity. Using a test light from +12 to the ground in question will tell you more (though not enough) about quality by how bright the light is; but I wouldn't use a test light around the ECU just in case some sender return is very delicate (not to mention hitting the wrong pin).

Yrs, d


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.