My point was that the spindle should not be so worn that the bearing inner races are a loose or sloppy fit. They may spin when the wheel is unloaded but so little that you know they are spinning while traveling. Yes they are behind the thrust washer. Dennis -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of David Beierl Sent: Saturday, June 16, 2012 11:13 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: PEX front bearings WARNING-big brake kits! At 06:56 PM 6/16/2012, Dennis Haynes wrote: >The inner race should not spin with the bearing loaded. I have seen >many bearings haves short lives due to improper installation. Dennis, do you mean with the preload on, or with the vehicle standing on its wheels? Also, isn't it hidden by the thrust washer? Or did I fall off at the last curve? Yours, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.