After installing a new Go Westy propane tank I kinked the copper lines to the point where they will have to be replaced. I see the stove-frige fittings when looking up through the cabinet. Before I tackle the rusted screws on the floor plate the lines go through under the van is there some thing under it that I need to look out for? Is running the new lines a simple matter of feeding the new line up to the stove and bending the lines (with a bender this time) in the right spots. The tank install was bear in itself (see other post). Thanks for any help. Spencer 85 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.