> > So, I'm down in Virginia Beach, VA and not near my usual shop that does AC > in Northern Viringia, when I lost my AC again in my 90 Westy (2WD, stock > 2.1L). (I'm down here two more weeks before I have to drive the van back up > to NoVA; so hoping I can get the AC fixed before then). > > The hose between the condensor in the upper cabinet and the dryer blew (it > was the one hose that looked good and I didn't replace it - lesson learned; > looks can be deceiving). It has this two-service-port connector in the > middle. Seems to me it should be simple enough to get fabricated at a hose > shop. My question is if this 2-service port fitting is just for the high > and low pressure sensors, or, if there some other purpose that these do? > Seems like its nothing more than a 8" tube with a compression fitting at > each end and two service ports. > > Hopefully, the link below will work or you to see the pic I posted on my > Picasa account. > > Thanks, > Gregg > 90 Westy (Blueberry) continuing the never ending AC battle > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.