Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2012, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 3 Sep 2012 19:39:57 -0600
Reply-To:     OlRivrRat <OlRivrRat@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         OlRivrRat <OlRivrRat@COMCAST.NET>
Subject:      Re: Still need HELP with hot start problem 84 Vanagon!
Comments: To: George Averill <averill@MCHSI.COM>
In-Reply-To:  <0AA9AD8F02674D53A0C92A63DED754A9@George>
Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

Why haven't you changed the starter yet?

ORR ~ DeanB

On 3 Sep , 2012, at 6:52 PM, George Averill wrote:

> All, > Well, I need some more help. I thought I had the problem solved, > but it seems I don't. If I keep replacing items, I may soon have a > new bus! > > The problem is that the van will not start for about 45 minutes > after it reaches running temperature and I turn it off. It runs > great while it is running. Cold start is not a problem. No > problems at all. If I drive about 20 miles and go in a store, when > I return it won't crank. If I wait for another 45 minutes or so it > cranks. Drive a few miles, turn it off to go in another store, and > the same thing happens again. The engine turns over, but no > cylinders fire. > > I have done the following > 1. Replaced the ignition switch > 2. Replaced the coil > 3. Replaced the fuel pressure regulator > 4. Replaced the idle module > 5. Replaced the air valve > 6. Replaced the injectors > 7. Cleaned all ground connectors, those on the motor and the > bonding cable between the frame and the transmission. The van has > never been to the beach or run on salted roads. No corrosion any > place. > 8. Replaced the temperature sensor. > 9. Replaced the wire from the computer to the temperature sensor. > > Tomorrow I am going to see if I can find some liquid air and try > cooling down some connectors to see if that may be a problem. I > think that the last time this happened it was getting fire. I will > check again to be certain. > > Any suggestions will be appreciated. I'm getting too old to keep > this up much longer. > > George > 84, Georgia


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.