Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2012, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 5 Sep 2012 01:10:29 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Fridge question
Comments: To: tom ring <taring@TARING.ORG>
In-Reply-To:  <5046A91A.7213.1EA77595@taring.taring.org>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 09:21 PM 9/4/2012, tom ring wrote: >My fridge works fine on 120 and propane but poorly on 12 volts. I >have checked >and it draws 6.3 amps on "12" volts which seems to be as expected.

Check along the 12 V wiring for voltage drops. Replace fuse on pillar with a Littelfuse glass version that isn't prone to losing contact at the retaining hole as the Euro fuses do. Increase spring tension there.

Check using an inverter to power it on 110 V while you're driving down the road. The fridge never works as well when under way as the vehicle's motion interferes to some extent with the internal flows. If no inverter, use propane. If you stick a thermometer on the cooling fins/tube with heat sink compound and cover it with putty you'll be able to see fin temperature rise within moments of driving off.

Check supply voltage at load end of fuse and current (ammeter inserted in line with fuse -- I think the supply wires on that fixture use screw terminals). Leave the fuse in circuit since by its nature it produces a voltage drop. Product of voltage and amperage should be at least 85 watts (rating of the heater). If not there's a poor connection somewhere and/or thicker wires needed. Poor connection may be on top of the fridge.

If above checks are ok, pull fridge and investigate the heater pocket - heater is held in with a setscrew. Rarely they break off the boiler, otherwise it's possible that corrosion may be interfering with heat transfer (not too likely given that the identical AC setup seems ok).

The easiest overall solution *may* be to simply use an inverter on the road. This minimizes voltage drops (taken as percentage of the total) and lets you have a thermostat without modifying the fridge.

Yours, David


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.