the spacer will slide over to the side ...there's room in the housing for that. I get a long thin punch in there I think..to drive out the outer race with rollers. never had a problem.
On 9/29/2012 6:04 PM, Gene P wrote: > I have the bearing housing on the bench, looking to disassemble to clean > and repack. Bentley 42.4-5 says "remove outer bearing inner race and then > spacer". Inner race slides out, but spacer does not. I have it cleaned up > an it looks clearly like the spacer is too wide (diameter) to slide through > that outer bearing. And of course, absolutely too wide to clear inner > bearing. Since you can't get a drift in to knock out either bearing with > the spacer there, how does it come apart? > > This seems like a dumb question but I just don't see it. What am I missing? > > Thanks for any help... > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.