In my experience the ground wire is usually fairly short and simply attaches to the frame right near where the pump is mounted. Now, I cannot say for sure that is the stock location because there is a chance that everyone I have dealt with has been previous altered by a PO - however since that was the case in all 4 of the vanagon's I am familiar with I would say it's a good chance that is the "normal" location. Screws to the frame on the side that faces to the middle of the vehicle.
-- Thanks, Jeff '85 GL (Gertie) '78 Bus (Melissa) Patty's Bus |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.