Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2012, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 14 Oct 2012 17:33:38 -0700
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: WowWowWowWowWow sound when rolling on down
Comments: To: JRodgers <jrodgers113@GMAIL.COM>
In-Reply-To:  <507B3247.4060704@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

one very good test for tired/worn wheel bearings is to drive about 35 to 40 mph and sweve gently, listening for the sound to be worse swearing one direction, and less swerving to the other direction.

- the idea being that the bad bearing/s are on the quieter side , as the load is less on those bearing swerving to that direction. Can't figure out what '0l means.. ,makes me think of a 2001 vehicle. oh I get it .. it's your way of abbreviating it's Ole Red and Ole Blue. Closest to that would be Ol' in normal english I'd think.

Did you raise the wheels off the ground and wiggle ? I just check of up-down play at the rear wheels ....1/8th inch is normal wear with high miles, beyond that is 'getting due' at least. Fronts should have basically zero slop there, as they are easily serviced and adjusted.

scott turbovans

On 10/14/2012 2:44 PM, JRodgers wrote: > I have this sound in the running gear on 'Ol Red. I have the same new > General Altimax RT tire on both of my '88 vanagons - 'Ol Red and 'Ol > Blue - so I decided to swap the the tires between the machines - one at > a time - and see if I could isolate a particular tire/rim. Swap > completed for all wheel/tires and the sound is still there. So it wasn't > in the tires/wheels. So that means???? I can only think of bearings, but > in my experience a wheel bearing produces a distinctive and continuous > growl when it's near death. I have no vibrations, and no pulling one way > or another - so there doesn't appear to be anything bent or out of > alignment. I'm mystified. Any ideas, anyone? > > Thanks, > > John >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.