did you check how 'flat' the new covers fit on the heads ? ( not actually sure if you reallymean new covers or just new gaskets ) in either case ... like do they rock slightly ..like they are not flat ? I saw others' posts about gluing them to the VC's and grease on the head side. I just put them on dry and they work fine usually. I have one valve cover amoung my many that will not seal ... it's just faultysomehow. I'd try the old ones back on .. swapped side-to-side. Scott turbovans
On 10/26/2012 4:24 PM, Don Preston wrote: > Hi all, > > So, while replacing the exhaust system a couple weeks ago I also replaced the rocker covers, with new cork seals, as one of them was leaking. Thing is, now both covers have slow leaks, yay! > > Anyone run into this? Tried bending clips to get as tight a seal as I could, and made sure the seals are contacting properly. Ideas? > > Don > '87 2.1 Vanagon GL ASI |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.