hello, I have one of the usual aftermarket Audiovox cruise controls on my 86 with AT. I think it's model CCS-100? I use the magnet speed sensor kit on my drive shaft. It's not working well. It engages briefly and then immediately disengages. It will then attempt to resume to that speed if I press that button, but immediately disengage. That makes me think that it is at least remembering the speed I set it to. I've gone through the troubleshooting of all the wires as the instruction manual specifies, and everything is good. I'm wondering if I could devise some way to monitor it from the driver's seat to figure out what is going on. Thanks for any advice. Edward |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.