> I just gave this a try, and I was able to turn it about a half turn with > this method. I think I got a little eager/careless and ended up destroying > the bit I was pushing against, though. > > But this is good information--I think it would be possible to continue with > this route if nothing else was available, and if you hadn't suggested it, > it wouldn't have occurred to me to try.
You might keep trying that route - it is much easier than lowering the rad (and draining coolant). Try just turning with just your finger tip or perhaps a bit of rubber over it. If it is rough at all, it'll keep spinning - there is not much pressure on it, unless the threads got mangled.
> So, to lower the radiator, is it just unplug the fan and the sensor at the > front bottom driver side, then undo the four bolts on the little > "mini-shelfs" (I looked it up, that's what they call them in the Bentley) > that it rests on? It looks like the hoses will have enough play that I can > move it a significant amount without taking them off. Yes, dropping the rad is pretty easy - as Scott said, you probably want to disconnect the coolant pipes (and have buckets ready to catch it) - you might be able to do it without that, but it is probably easier to remove the rad all the way. You probably want a helper to hold the rad while you go underneath and loosen the bolts. My dear wife helped steady it (and was ready to witness the execution by radiator guillotine).... but it all turned out ok. My old rad was pretty heavy - the new one not so much. Tom |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.