Hi Neil.. I happen to have a couple of stock DV 1.6 NA exhaust systems that have a flex pipe in the header pipe, fwiw. so at some point, 'someone' ...aftermarket manufacturerof VW did have a DV exhaust with a flex section in it. personally ..I have never had the need to put one in any vanagon engine conversion exhaust system. I 'could' ..even been saving a nice large diameter one for years. .. just never had the need. Ilike it 'all' mounted to the engine .. with proper support and all that ..whether subaru, TD . whatever. 1.9 TD inline four engines vibrate 'nicely '.. I haven't found the need on those , for example. re crack-prevention .. subauru conversions are prone to that .. the latest KEP exhaust headers I have has a slip joint in it ... about 5 inches of overlapping close fitting pipe , one inside the other. Instructions say very clearly ..............do not weld.. do not add brackets etc. so 'some give' is appropriate in some systems for sure. hanging from the body though .. I'm still not in favor of that. here's another example .....EZ3.0 6 cylinder engine in a Syncro Vanagon ...done by smallcar. They mount the engine using the stock ruber subaru engine moounts witn en under-engine cross bar. at the rear...they have the stock vanagon rear engine mustache bar .. that's used to hold the muffler on ( there is a flex section too ) ..and for mounting the aft end of the skid plate to. kinda clever. worst thing is you have to remove the skid plate to get the muffler off.. as the bolts at the back end of the skid plate are captured by the muffler. On all syncro's the muffler or skid plate will come off independently of each other .. but that's not all that bad. S.
On 12/20/2012 6:17 PM, neil n wrote: > Or looking at it from a different POV...... > > Is this a flex bellows I'm seeing? image of 1.7 KY diesel exhaust diagram: > > http://tinyurl.com/cm4n2oc > > Maybe used due to increase in displacement? > > I'm really sorry to be beating a dead horse here, but for me, there > still seems to be a little voodoo on exhaust design and longevity on > gas I4 swaps. > > Maybe I'll read Alistair Bell's exhaust pages again! :^) > > > Neil. > > On Thu, Dec 20, 2012 at 4:33 PM, neil n <musomuso@gmail.com> wrote: > > >> i.e. why didn't they use a flex joint and hang the exhaust from the >> body with rubber isolators? > > > > -- > Neil n > > 65 kb image Myford Ready For Assembly http://tinyurl.com/64sx4rp > > '88 Slate Blue Westy to be named. > > '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ > > Vanagon VAG Gas I4/VR Swap Google Group: > > http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.