Hi all. This is for a 1981 formerly air cooled Vanagon with a self installed Jetta 2.0 OBD1 engine. My good DMM (20 Amp rated) had a blown fuse so I took a chance using my 10 Amp rated DMM. With DMM connected in series between 30 (B+) and 30 of an added relay to carry power to ECU and coil, engine cold, DMM set to 10 Amp scale: engine off: no current draw (makes sense) idle: 1 - 1.5 Amps 2K RPM: roughly 2.5 Amps which increased as RPM increased. Highest was about 3K - 4K RPM. I also ran the test with the new relay UN-installed; DMM in series between 30 and coil/ECU wire, effectively bypassing the ignition switch. Same results. (btw. When I inserted the DMM probe to meter, the fuel pump primed each time I made the connection. I'm certain that supplying + to 38 of ECU energizes the ECU so that it can energize the fuel pump relay by supplying a ground) This is somewhat embarrassing! Unless I'm doing and reading things wrong, well, even though it's a long wire, I guess the OEM #16 wire should handle the load(s) created by the Jetta ECU and coil. Like one chart shows #16 wire at 12 Volts, 10 Amps, has a maximum length is 25'. And, any increased wear and tear on the Vanagon ignition switch is likely small, they fail at some point regardless, so I highly doubt any of this caused the mysterious highway speed stall I had. Caveat: I have NO idea if increases in engine temperature, ambient temperature, etc. would affect the actual current drawn. i.e. in a real life driving scenario. Also, I am not a scientist, electrician or qualified in any other related way. ;^) The instrument cluster was not connected to the 15 circuit while testing so the VSS, dynamic oil pressure board, etc. did not load the circuit. My guess is that any current increase due to those parts would likely be negligible. Thanks
Neil. On Sat, Jan 26, 2013 at 3:50 PM, Scott Daniel - Turbovans <scottdaniel@turbovans.com> wrote:
> how much current do you figure your ECU draws ?
On Sun, Jan 27, 2013 at 1:10 PM, Ryan Press <ryan@presslab.us> wrote:
> I think it would help if we knew how much current the ECU actually draws, > and how much the coil draws. Can you measure these with an ammeter both > while running and not? -- Neil n 65 kb image Myford Ready For Assembly http://tinyurl.com/64sx4rp '88 Slate Blue Westy to be named. '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ Vanagon VAG Gas I4/VR Swap Google Group: http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.