Hi, My copy of Bentley says 37 ft lbs for those head nuts, page 15.29. I don't think that taking them from wherethey, and have been there for years , even stuck, to see ifthey'll turn more to the torque spec isn't a very valid test ....In my mind they should be moving up from say ...30ft lbs to 37. You should be able to get that barrel loose ..lotsof penetrating oil.. pry boths sides with a back and forth tilting action .. numerous applications of penetrating oil. Kroil in the orange spary can is considered the best one ...PB being the next best one , IMO. you'll get it. I've never used a torch for heat there, just never had too. 15 years ay .....I get nervous when wbxr heads have been on a really long time .. things tend to corrodedor get stuck . Scott www.turbovans.com On 2/12/2013 7:22 PM, Walter Houle wrote: > Update: I'm still looking for the cause. I pressurized the cooling system > with 15 PSI and didn't see any leaks. Next, I pressurized each cylinder > with 100 PSI shop air and did not get any leaks into the cooling system, > either. The torque on all the head bolts was OK at 33 ft lbs. I then > pulled the low compression head part way off. it didn't look that bad, > there actually was minimal corrosion underneath the outer gasket, and I > didn't see any cracks. The cylinders were hard to pry off the head but > they came loose with some effort with a pry bar and some PB blaster. There > was some slight discoloration on the end of the cylinder barrels where > they fit in the head. On to the next head. this time one head stud felt a > little soft. It took about a quarter turn before the wrench clicked. > That's as far as I got. I'm still trying to get the head all the way off. > One cylinder barrel is stuck. I have tried soaking it in PB blaster and > various pry bars on those little tabs to no avail. > > Any recommendations on how to get this cylinder loose? The engine is in > the van and the van is in the garage so I am reluctant to try any heat. > > Thanks, > Walter > 1985 1.9 that has been unopened for 15 years ... > > > > > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.