Date:         Sun, 17 Mar 2013 19:54:14 -0700
Reply-To:     neil n <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil n <musomuso@GMAIL.COM>
Subject:      Re: Flat Style Rear Bed Refoam. Now: Seat Compressor. Worked
Comments: To: all listees <wetwesties@yahoogroups.com>
Content-Type: text/plain; charset=ISO-8859-1

Hi all.

So this was a bit of a risk and a "Hail Mary" idea, but it worked pretty good.

Idea:  (sorry for bad lighting and use of dining room table)

https://lh6.googleusercontent.com/-RuPbuJVvWUI/UUaARQTiToI/AAAAAAAAHNo/d_auMeNm1dw/s900/Foam%2520Compress%2520.jpg

rear edge of bench

https://lh5.googleusercontent.com/-HNZm50vGmwo/UUaASOHOOXI/AAAAAAAAHNw/TVE9BeiAiEw/s512/Foam%2520tightened.jpg

you can see how fabric pulled a little. Any slight pulling on front
edge is very very minimal. Like you have to hold the piece to your eye
and look down the edge. I certainly can't feel any defects.

Un-tested as of yet, but this "technique" for sure tightened up the
fabric. Like by 3/4"  maybe? I suspect I fixed the sloppiness.

Neil.

On Sun, Mar 17, 2013 at 12:52 PM, neil n <musomuso@gmail.com> wrote:

> Since I didn't pull the fabric really tight (on purpose. for aesthetic
> reasons) I may try lightly clamping 2"x4" along rear of bench. Why:
> this will compress foam slightly, create slack in fabric, this slack
> could be pulled in and stapled at rear of bench. Compression released,
> fabric will be tighter. Risk: bunching at sides.

--
Neil n

65 kb image Myford Ready For Assembly  http://tinyurl.com/64sx4rp

'88 Slate Blue Westy to be named.

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG Gas I4/VR Swap Google Group:

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines