Date: Wed, 17 Apr 2013 16:47:59 -0700
Reply-To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject: Re: Syncro Transaxle Leaking
In-Reply-To: <516F0C26.1060802@qadas.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
MT90 is not considered to be the good juice anymore in sycnro's ..
might want to change that in any case.
Swepco is recommended..
and German Transaxle fairly insists on Ultra Guarg 75 W 90.
good thinking on thebreather hole and tube, I'd want to be very very
sure though.
Also .....full to the bottom of the hole is not the spec for
full...should be down a little from there.
I'm sure you've considered drive shaft balance, u-joints not being stiff
( on all the original drive-shafts I see, I usually find the rear
u-joint stiff in one plane. ) .
or bearing in the housing where the seal is,
or flange itself in some way.
A 2" spot is more than seeping to me. I'd want that fixed.
I don't get the impression the nose of the trans is the strongest or
best built transmission part in the world either.
Indeed, a leaking seal is not always just the seal ...
it can indicate other tired things in the area.
I hope you find it and all goes well.
Scott
turbovans.com
On 4/17/2013 1:55 PM, Jon Kanas wrote:
> Greetings all,
>
> This is on a 1987 Syncro Westfalia, with slightly under
> 135KMi on it. Currently I am running RedLine MT90 in the
> transaxle, and generally satisfied with the overall behavior
> of the transaxle. I just returned from a quick trip to the
> Needles district of Canyonlands (+/- 900mi) which was
> absolutely uneventful (I did meet a couple of other Vanagon
> folks there!!) The transaxle does not have any obvious
> problems, noises or vibrations.
>
> I have a persistent leak where the stub for the driveshaft
> comes out of the front of the transaxle. We're on the
> second seal replacement. The first replacement was an
> aftermarket seal, then we went to the appropriate OEM seal
> provided by German Transaxle. This is not a significant
> leak, leaving about a 2" spot on the driveway after a long
> drive. It's bugging me as I don't want to inadvertently run
> the transaxle out of oil during a long trip and I don't like
> spots on the driveway.
>
> I'm wondering if anyone on the list has encountered a
> similar problem, and has any suggestions for a permanent
> fix. I'm becoming concerned that the leak is an indication
> of a problem with the output shaft... I have verified that
> the transaxle vent hose is not obstructed.
> --
>
> *Best Regards,
> Jon B Kanas
> *Email: kanas@qadas.com <mailto:kanas@qadas.com>
> Website: http://www.2experts.org
> <http://http://www.2experts.org/>
> *Longmont, Colorado; Cultural Center of the Universe*
>
> *
>
>
> *
>
> **
>
|