I have tried the bending method. Though heating the arm up a *little* helped, and they lasted a short while, they eventually snapped. I am currently using a couple of washers to fur the handle out a bit but looking at this image of your speaker http://2.bp.blogspot.com/-jl9AArBYPdo/UXMIWqWhytI/AAAAAAAAAwM/3d28KTHO6Yc/s1600/Door1.jpeg this may not work. Neil. On Sat, Apr 20, 2013 at 3:41 PM, J B <jbever@excite.com> wrote:
> .... I ended up bending my original cranks out slightly so they wouldn't hit the speaker covers that stick out about a 1/2 inch but the cranks have now broken off.
-- Neil n Blog: tubaneil.blogspot.ca '88 Westy http://tinyurl.com/c8rlw6p '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ Vanagon VAG Gas inline-VR Engine Swap Group: |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.