I completely dismatle them, remove the bulk of the grease with paper towels, then spray them with brake cleaner to melt off the rest. Allow to fully dry, scrub clean, and reassemble/pack with fresh grease. -Craig
On Mon, Apr 22, 2013 at 1:45 PM, Jeff Lincoln <magikvw@gmail.com> wrote: > I finally got to starting the clutch replacement on Gertie ('85, 1.9) > > When I got the axles removed fromt he trans I discovered that the passenger > side CV seems to have some pretty old grease in it. ANy suggestions on the > best way to clean that up and prepare it for adding some fresh grease - > Without disassembling it. I mean I can figure it out on the basic side but > is there anything I shouldn't do - or anything specific I should do? > > The Driver side looked fine and has some nice clean grease in it. > > Advice as always is appreciated. > Thanks, > > Jeff > '85 GL (Gertie) > '78 Bus (Melissa) Patty's Bus > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.