Date:         Tue, 30 Apr 2013 22:07:47 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Painting the exhaust - High Temp - POR??
Comments: To: Jeff Lincoln <magikvw@GMAIL.COM>
In-Reply-To:  <CA+Spi20WOci75ne0f5ngKKmCyEZviYPxoTGMQ9+_Mn7Z41ZpLA@mail.gmail.com>
Content-Type: text/plain; charset="iso-8859-1"

Unless your planning on doing this say every oil change I wouldn't bother.
Longest life will be had with regular use. Short drive cycles and letting
the van sit will also mean the exhaust will rust from the inside out. At
this point it is most likely a Dansk brand exhaust so in addition to rust
there will be flange failures or the pipes themselves will crack usually in
the bend just after the flanges. Just use good hardware and anti seize so
the parts are easy to change when needed. When the engine pipes need
replacing consider going to the 86+ exhaust. Changing the rear mount casting
will also allow you to use the later muffler and supports.

Dennis


-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Jeff Lincoln
Sent: Monday, April 29, 2013 4:03 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Painting the exhaust - High Temp - POR??

So while I'm under the bus working on the clutch I had an exhaust issue to
fix (rusted through at collector). The headers are crusty but not close to
rusted through. I'd like to paint them with a POR type paint - POR has a
couple of High temp options (Black Velvet and POR-20 Aluminum) The first
rated for 1200° and the other for 1400° - the aluminum says it is salt an
weather resistant.

So the Aluminum sounds like it fits the bill but POR says to use regular
POR-15 (as long as the parts don't exceed 450°). I think they didn't catch
what I was asking them :)

Anyone ever used the aluminum stuff? Or other products?
Thanks,

Jeff
'85 GL (Gertie)
'78 Bus (Melissa) Patty's Bus