Ben wins the prize for clarifying the name of the tool required...I get the booby prize for not being more specific on my needs...things are a little fuzzy right now as a recover from a concussion...reminder to self, you are 65 in a couple of months, and although you have picked up short blocks from the ground many many times to put them on the stand, you need to be well balanced or you will high side over them and land on the top of your head on the cement...getting your bell rung is the strangest internal sound you will ever hear LOL I need to open up the width of the sleeve landing surface/pocket in the head for wider cylinders/sleeves...this is a bolt on tool to the head or case (as I recall) that is driven by a drill press, and yes the cutting speed needs to be very slow and accurate, just knowing the name brought back a lot of memories. Does anyone have one of these they are not using, or would be willing to loan out, or sell...or have a supplier they trust to buy one from? Thanks again Ben. >________________________________ > From: Ben <syncro@gmail.com> >To: den jolliffe <sondancer77@YAHOO.COM> >Cc: "vanagon@GERRY.VANAGON.COM" <vanagon@GERRY.VANAGON.COM> >Sent: Friday, May 10, 2013 10:08:03 PM >Subject: Re: Cutting tool question...cylinder head pocket > > >Sounds to like the young man is looking for a "flycutter". Chuck it out. > > >BenT >sent from my electronic leash > >On May 10, 2013, at 6:28 PM, den jolliffe <sondancer77@YAHOO.COM> wrote: > >> I'm looking to open up the pocket width on some air cooled heads for an engine build on my 81 camper...trying to find a little more HP...just a little. >> >> I recall there was a cutter in my collection some 25 years ago to do this kind of thing, but most of that stuff is long gone once I closed the shop...now I'm looking for it again, go figure. >> >> Can anyone enlighten me....same tool will help me open up some 1.7 heads for another project and move it to drivability for the summer...been at that one nearly 10 years, so it's time. >> >> Thanks, Den. > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.