If you must buy one here's a couple of places you can check out: http://www.geneberg.com/cat.php?cPath=392_2919 http://www.piersideparts.net/SE98016.html There was one for sale a few months ago on the Samba for less than half the prices quoted above but looks like it sold.
BenT sent from my electronic leash On May 11, 2013, at 7:24 AM, den jolliffe <sondancer77@YAHOO.COM> wrote: > I need to open up the width of the sleeve landing surface/pocket in the head for wider cylinders/sleeves...this is a bolt on tool to the head or case (as I recall) that is driven by a drill press, and yes the cutting speed needs to be very slow and accurate, just knowing the name brought back a lot of memories. > > Does anyone have one of these they are not using, or would be willing to loan out, or sell...or have a supplier they trust to buy one from? > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.