Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2013, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 10 May 2013 22:26:52 -0500
Reply-To:     raceingcajun <raceingcajun@COMMUNICOMM.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         raceingcajun <raceingcajun@COMMUNICOMM.COM>
Subject:      Re: Cutting tool question...cylinder head pocket
Comments: To: den jolliffe <sondancer77@YAHOO.COM>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
              reply-type=original

How about it Den, could you be a little more specific as to what you wish to accomplish? Cutting the combustion chambers or the valve pockets and ports.

Howard

Subject: Cutting tool question...cylinder head pocket

I'm looking to open up the pocket width on some air cooled heads for an engine build on my 81 camper...trying to find a little more HP...just a little.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.