Wouldn't it be easier to remove the bolts from the trans mount to body and just lower the tranny some? -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of mark drillock Sent: Friday, May 17, 2013 3:19 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Rear spring question Stock 2wd Diesel Vanagons have the tranny nose mounted much higher than gas Vanagons due to a different nose bracket used in diesels for this purpose. This means the CV axles are always at a greater angle in those diesel 2wd models. When you are trying to change the springs the limiting factor can be the operating angle of the CV joints limiting the range of motion of the axle as you push down on the drum. It will only move so far before the CV joints bind. Loosening the CV bolts at the tranny end lets the axle get more angle without requiring the joints to flex more. You may need to remove the CV upper bolts and loosen the others a lot. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.