Check the diameter of the receiver on yours, but it fit mine. I think this one said it's 1 5/8" If I remember correctly, it was a little small for mine, but it clamped in fine with the locking bolt.
Stuart
From: John Meeks [mailto:vanagon@gmail.com] Sent: Saturday, June 01, 2013 6:20 PM To: Stuart MacMillan Cc: Vanagon List Subject: Re: For those working on the WBX out of the car
Stuart, Just to be sure before I order it, that link shows the mount fits 1971-73. Is it the case (pun) that it will mount the 2.1 WBX to a floor stand? Thanks, John Meeks '91 Multivan Stock 2.1 250k miles http://www.vanagonauts.com Vanagon Rescue Squad iPhone and Android apps On Jun 1, 2013 8:32 PM, "Stuart MacMillan" <stuartmacm@gmail.com> wrote: A VW engine mount works fine with the WBX and lets you install the clutch while on the stand. Here is the cheapest one I could find: http://tinyurl.com/mo9lk7p It will fit into a floor stand too.
I tossed mine out when I sold my '84, but I'm never working on a WBX again anyway.
Stuart |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.