Date:         Sat, 1 Jun 2013 18:49:13 -0500
Reply-To:     Jeff Palmer <jpalmer@MYMTS.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Palmer <jpalmer@MYMTS.NET>
Subject:      Re: Installing rear seatbelt on drivers side
Comments: To: mcneely4@COX.NET
In-Reply-To:  <20130601153953.0TRWP.491915.imail@eastrmwml208>
Content-Type: text/plain; charset="us-ascii"

All done!  Although I didn't see this post until later, and I didn't see any reference to torque in the instruction sheet - torqued it as much as I could by hand.  Was as least as tight as the receivers that I took out.

Jeff

On 2013-06-01, at 2:39 PM, Dave Mcneely wrote:

> Inside the storage compartment, on the bulkhead, there is a bolt.  That is the anchor point.  BTW, it is VERY difficult to fit the belt anchor to that point, because of having to work in the compartment.  There is a certain torque required (I don't remember it, but I am sure the manual gives it, and I know that the GoWesty kit does).  Being able to get a torque wrench in there and apply the torque is really, really tough to do.
> 
> mcneely
> 
> ---- Jeff Palmer <jpalmer@MYMTS.NET> wrote:
>> 85 Westfalia and installing the three point belt from Gowesty. Looking for the anchor point. How do I find it without tearing up the back is the storage compartment?
>> 
>> Thanks
>> Jeff
>> 
> 
> --
> David McNeely
>