John, Thanks for the reply. I tried to be as careful as I could putting that seal in - actually truth be told, my buddy did it and I was very adamant that he be as careful as possible - I'll do it myself next time. He's a great friend, but he can be a bit of a "bull in a china shop" :) I did not have the Flywheel machined - based on inspection by those I trust (and know their way around avanagon) I held off on that. But I did install the felt washer. I'm not looking forward to pulling the trans again - but it should go a lot easier this time since it was all recently removed and put back together. All new Flywheel bolts and everything else was properly cleaned and greased where appropriate. Thanks, Jeff '85 GL (Gertie) '78 Bus (Melissa) Patty's Bus |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.