Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2013, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Jun 2013 10:31:44 -0700
Reply-To:     Scott Ohana <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Ohana <scottdaniel@TURBOVANS.COM>
Organization: Cosmic Reminders
Subject:      Re: Engine installed and blowing a little smoke
Comments: To: Robert Anderson <robertanderson294@COMCAST.NET>
In-Reply-To:  <54A46795-2FE2-446B-AD87-E2346C25BC1E@comcast.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

it's always good to run any freshly assembled engine under load for a while.. just in case there is .......say ....anti-frz from failed head gaskets in the muffler.

also .....if an engine with a head gaskets failing sits with anti-frz in the cylinders for a year .... I can't imagine that that would be very good for rings and cylinder walls. Normally not a problem ....and .....it sure was never designed to sit with old anti-freeze or water in the cylindersfor a long time. Could be a factor .

this could fall under..... 'the longer one waits to repair a known failure ........the worse things get, and more expensive too.'

Reminds me of someone letting a dead car or vanagon sit for years with the parking brake on very firmly. That happened to one of my very best vanagons before I got it ...87 Wolfsburg.. the guy, a car nut too, let it sit with the parking brake on hard for a long time. It never even occured to him that that couldbe rough on things, as in stuck cables or shoes rusted to drums, etc.

Sure gotta give credit to Vanagons and VW .. Vanagons endure just incredible abuse and neglect and manage to not suffer too, too much, quite often.

On 6/25/2013 4:41 AM, Robert Anderson wrote: > Hello All, > After a winter project of replacing the head gaskets in my 2.1 engine, I now have the engine back in and just started it up and she sounds good, however she is blowing a little smoke when I rev up the gas. Prior to my doing the head gaskets this engine sat out for about a year. I'm wondering if a little smoking is normal and should clear up after running for a while? > Thanks, > Bob Anderson > Wilmington, MA > > Sent from my iPad


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.