Date:         Fri, 28 Jun 2013 06:30:20 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Pressing control arm bushings
Content-Type: text/plain; charset=ISO-8859-1

Craig Cowan was asking about upper control arm bushings and got some good
answers. I am about to replace every bushing in my entire suspension, front
and rear, and was wondering about the other bushings that do have to be
pressed out and in.

Is this something that can be done with a large vise or some allthread with
nuts and washers, or do I need to send the lower fronts and rears out to a
shop?

Thanks,

Jim

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.