Date:         Wed, 3 Jul 2013 13:44:06 -0600
Reply-To:     ralph meyermann <ralphmeyermann@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         ralph meyermann <ralphmeyermann@GMAIL.COM>
Subject:      Re: Tricks to ball joint removal without Pickel fork?
Comments: To: phishman068@gmail.com
In-Reply-To:  <AE37B40C-569B-4AF0-83FB-FDB0AFBD1FF2@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

Depending on if there is enough room and you have a 4 1/2" grinder with a
cut off wheel, you can cut them out. Pretty sure thats what I had to do
with mine but I had the spindles completely removed for a full front end
rebuild!

Velma 82 na diesel westy
On Jul 3, 2013 2:20 PM, "Craig Cowan" <phishman068@gmail.com> wrote:

> I've got to pull two upper ball joints which are just spinning (have the
> bolts half out) and no Pickel fork.
> Any suggestions?
>
> Thanks!
> -craig

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.