Date: Sun, 28 Jul 2013 07:27:50 -0700
Reply-To: Paul Rogers <wognacious@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Paul Rogers <wognacious@GMAIL.COM>
Subject: Re: What Oil to Use on Startup?
In-Reply-To: <BAY179-DS31CCB4449096CBDF55899A0540@phx.gbl>
Content-Type: text/plain; charset=us-ascii
Thanks to all of of you who chimed in. I should have clarified some info on the engine. The guy I got it from is a mechanic and former Vanagon owner. He put this brand new engine, at the time, in his van but had to pull it after 800 plus miles because it was going through lots of oil. So he pulled this one and put another one in his van. Opened this one up and found it had a bad ring or rings. Fixed the problem but never used it again. And now I've got it. There is a very small amount of oil in it but not enough to show on the dipstick. Actually I bought the long block and I'm using the necessary parts from my 1.9 on this 2.1. So I'm almost ready to fire it up but being it hasn't been run in a year or two I wanted to be cautious about the initial start up and not waste $30 or so of Mobil1 in the event there are complications.
Thanx again and any sage advice about this initial start up would be gratefully appreciated. I've got a fair amount of $$ invested and would hate to do something to muck it up. My plan is to crank it over without spark or gas until the oil pressure builds up and then go for it. I installed an OP gauge too.
Paul in Tracy
Sent from my iPad
On Jul 27, 2013, at 7:22 PM, Dennis Haynes <d23haynes57@hotmail.com> wrote:
> If there is still oil in it and there is no reason to suspect it was
> contaminated start it with that and once all is proven well then change it
> to what you wish to use. If you do change it first and there is a problem
> the cost of the oil will likely be the least of your concerns.
>
> Dennis
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
> Paul Rogers
> Sent: Saturday, July 27, 2013 12:49 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: What Oil to Use on Startup?
>
> Howdy, I'm preparing for starting up, hopefully, my new to me motor.
> According to the seller it has around 900 miles on it. But it's been sitting
> around for a while. I know it's been over 1 year minimum. Long term I'm
> going to use Mobil 1 but I'm thinking for the initial start up using
> something less spendy in the event something doesn't go as planned. I'd
> really hate to waste $30 plus $$ of the Mobil 1. Any thoughts on this matter
> would be gratefully appreciated. Wish me luck.
> Paul in Tracy
> I don't think it matters but the motor is a 2.1
>
> Sent from my iPlace
>
|