Date: Tue, 23 Jul 2013 14:37:49 -0400
Reply-To: Stuart Fedak <ve3smf@YAHOO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stuart Fedak <ve3smf@YAHOO.COM>
Subject: Re: Vanagon fuel injector cleaning
In-Reply-To: <0MQE001FJGRUL340@vms173021.mailsrvcs.net>
Content-Type: text/plain; charset=us-ascii
http://m.youtube.com/watch?v=VFJlTfHyrUk
This is the best YouTube video that I came across. It shows the basic process to clean and back flush the injectors. It appears he uses both 12 VDC from the vehicle battery or from a DC wall wart converter. I have been told that the electrical connector used for the Vanagon fuel injectors is also used on many North American cars, and is readily available at NAPA or other stores (not confirmed). Yes, I would use a momentary push button switch (NO). It seems to be worth the effort to make up a test wiring harness to do this job, rather than risking damaging the solenoid on the fuel injector.
I can see in Bentley, for my vehicle page 97.89 that all four fuel injectors fire at the same time. In speaking with Frank C., he said that the fuel injection system on the Vanagon is very Olde Skoole and is really not that efficient. This is one of the reasons it goes through so much fuel, as compared to more modern fuel injection systems which adjust fuel right down to each cylinder. The reason this came up, as I was curious as to why there was not a better way to identify the fuel injector harness. They both look the same on both sides of the engine. That is when he said it does not matter which fuel injector harness is connected to the fuel injectors, as they all fire at the same time.
Cheers!
Stuart
86 Vanagon GL 2.1
Sent from my electronic umbilicus
On 2013-07-23, at 1:33 PM, Project Pat <psdooley@VERIZON.NET> wrote:
> The injectors get 12 volts.
> My concern is the duty cycle though. The voltage is pulsed, not continuous.
> The Vanagon injectors may be robust enough to take continuous voltage for a
> few seconds, but I'm not sure.
> I suppose the momentary switch and a fast finger would suffice.
>
> I have checked injector patterns by simply plugging a spare test harness to
> the injectors and tapping the positive wire on the battery terminal.
> This is done off the vehicle with the injectors plugged into a spare intake
> manifold and fed fuel pressure.
> I haven't killed any injectors yet, but YMMV.
>
> I really like the idea of back flushing the injectors. That should really
> help clear debris as opposed to trying to push it through.
>