Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2013, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 29 Jul 2013 12:50:55 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Blinking temperature light
Comments: To: Goetz Aust <gkaust@gmail.com>
In-Reply-To:  <CA+rcdKWGjqN0CXGpSJ06pJmVN=SqM34ka_G6QyAJuHVMwjy3QQ@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

A bad ground to the instrument cluster or a damaged connector to the instrument cluster at the ground wires will cause this symptom.

So will a temp gauge gone bad.

Jim

On Mon, Jul 29, 2013 at 12:45 PM, Goetz Aust <gkaust@gmail.com> wrote:

> Pressure tank appears full based on color and temperature at top . No > visible leaks on ground - its raining now. Also the temp gauge flashes 6 or > 10 times before starting and I thought it should only flash 3times. > > On Monday, July 29, 2013, kenneth wilford (Van-Again) wrote: > > > The flashing light is most likely because you are low on coolant in the > > tank that is inside the engine compartment with the pressure cap on it > > (black or blue). Open the engine lid and look at this tank (to the > left). > > If it is full then you have a problem with the sensor or the wiring. If > > it is low you need to investigate further to see why it is low (a coolant > > leak?). If you don't see any leaks, you could possibly continue to > drive, > > keeping an eye on the temperature. Or you could wait for it to cool off > a > > bit and then top off the coolant and this should make the light go out > and > > stay out. > > > > Let us know what you find. > > > > Ken Wilford > > John 3:16 > > www.vanagain.com > > > > > > On Mon, Jul 29, 2013 at 1:18 PM, Goetz Aust <gkaust@gmail.com<javascript:_e({}, > 'cvml', 'gkaust@gmail.com');> > > > wrote: > > > >> Travelling home in my 87 Vanagon and the temperature light keeps coming > >> on. > >> Outside temp about 50 deg F or 10 deg C. After blinking light comes on > it > >> stays on unless I stop. Also the front fan is not on while I'm stopped. > >> > >> The temperature gauge never seems to go much above the flashing light. > >> When > >> I stop restart and idle for awhile the front fan starts sometimes and > >> when > >> it does I can continue on my way for 10-20 miles before the temp > flashes. > >> Oil, coolant levels are fine and the belts seem good (im not a > mechanic). > >> > >> Question- am I Ok to drive the 40-50 miles home if I just watch the > >> temperature and keeping it below the 3/4 mark? Or do I need stop every > >> time > >> the flashing light goes on? > >> > > > > > > > > -- > > Thanks, > > Ken Wilford > > John 3:16 > > www.vanagain.com > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.