Hey. Neat! That'll stay together. I've been solar panel obsessed lately so please forgive me..... Had thought a short pipe sized to the Westy table leg OD welded to a bumper end, might allow the leg to support the Westy table, or, a solar panel support that swivelled. (for those using folding solar panels?) Crazy thought but while it was on my mind..... Drill a couple holes on arm for a cross pin, maybe add a screw clamp to pipe....
Neil.
On Thu, Aug 1, 2013 at 7:14 PM, Alistair Bell <albell@shaw.ca> wrote: > I ended up TIG'ing the assembly. Oh boy am I inconsistent, in life and in my welds. But the welds will be ground down a bit to make either a rounded or beveled corner. > > http://shufti.wordpress.com/2013/08/01/vanagon-bumper-build-part-2/
-- Neil n Blog: tubaneil.blogspot.ca '88 Westy http://tinyurl.com/c8rlw6p '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ Vanagon VAG Gas inline-VR Engine Swap Group: |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.