Thanks. What I needed to know. Jim On Aug 13, 2013, at 11:07 AM, MICHAEL H <vwdash80@YAHOO.COM> wrote: > Jim - if it's the main fan control switch, with the levers, the first tool you will need is patience. the fascia panel is held to the dash by 4 pins that break incredibly easily. after you pull the fan speed knob, use a butter knife from either end and slowly pry the panel about a 16th of an inch at a time alternating ends. if a pin breaks, it can be epoxied back onto the panel. when replacing the fascia, use a dab of anti-seize on the pins so you can pull the panel easier when you have to go back in for the light bulb. the secondary fan switch (rear heat) pops out far easier with just a flat bladed screw driver. h t h good luck ! mike > > > ________________________________ > From: James Ogul <jimogul70@GMAIL.COM> > To: vanagon@GERRY.VANAGON.COM > Sent: Tuesday, August 13, 2013 10:40 AM > Subject: Switch Question > > > Maybe an easy question from a novice. How do you change out the fan control switch on the dash board (85 Wsty). Does it pull out from the front or do you have to get at it from the back? > > Thanks > Jim > 85 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.