Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2013, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 20 Aug 2013 08:31:43 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Fridge sealant
Comments: To: ddbjorkman@verizon.net
In-Reply-To:  <4861426.1231947.1377005313555.JavaMail.root@vms170027>
Content-Type: text/plain; charset=ISO-8859-1

The "coils" I believe are supposed to be glued into place with heat-conducting cement available at radio shack. Please ask on the list specifically about that so you won't goof up something else that shouldn't have that material on it. I have seen what you are talking about assembled, but never had it apart.

Jim

On Tue, Aug 20, 2013 at 8:28 AM, <ddbjorkman@verizon.net> wrote:

> Hi Jim; > The area I am talking about is in the inside of the fridge behind the > "coils" or fins that cool the fridge. There is an area where the coolant > (ammonia) pipe enters the interior of the fridge through a hole in the back > behind the fins. I removed the old "putty" when wiring in an inside fan. > I also removed a dab of the stuff where the thermostat line goes in through > the back of the outside of the fridge. I hope I am explaining this > correctly. > > Dave B. > > > On 08/20/13, Jim Felder<jim.felder@GMAIL.COM> wrote: > > I am having trouble envisioning the size of gap you are trying to fill. > Plumbers putty is good when encased between two parts, but it can get > awfully crumbly is just left exposed and it doesn't have much structural > strength. > > I would think that household silicone caulk would be a better choice. > > Jim > > > On Tue, Aug 20, 2013 at 8:13 AM, David Bjorkman <ddbjorkman@verizon.net > >wrote: > > > I posted earlier and got no reply, so I'm trying again. > > I would like to know what is the proper putty or goop to close up pipe > and > > wire ports in a dometic fridge. I had to remove the putty inside the > > fridge around where the refrigerant pipe comes through and a dab where > the > > thermostat line comes through the back of the fridge. What is the common > > wisdom about what to replace it with? Is plumbers putty OK or is > something > > else supposed to be used? > > Any help would be appreciated. > > > > Dave B. > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.