At 12:25 PM 8/20/2013, neil n wrote: >between these parts. Too much paste might, to some degree, insulate >each part from the other. No "might" about it. The dirty little secret of heat-conducting paste is that it's a pretty good insulator. If you use more than the absolute bare minimum it will be worse than using none at all. What it's supposed to do is fill in the microscopic voids between the high spots where the metal actually touches. There's a lot more void area than contact area even on extremely smooth metal. The ideal installation would have all the voids filled but still have the high spots touching. This is practically impossible, but it's what you're shooting for. That's also the reason for the high clamping pressures on computer CPUs and such, to squeeze out excess paste as much as possible. Likewise why you shouldn't re-use the stuff after it's had the goo squeezed out of it. Clean it all off and start over. Yours, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.