Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2013, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 16 Aug 2013 23:38:35 -0500
Reply-To:     JRodgers <jrodgers113@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         JRodgers <jrodgers113@GMAIL.COM>
Subject:      Muffler Replacement Project - Torque Values Needed
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Having never found my Bentley after moving - I am a bit handicapped on certain Vanagon things.

I am replacing the three bolts that hold the J-pipe to the cast iron Y-manifold and just need the torque values for those bolts. These were burnt to a crisp and I'm putting in new ones. This is where the metal "donut" gasket goes in the exhaust system.

Anyone?

Thanks,

John


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.