Date:         Sat, 17 Aug 2013 11:03:46 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Muffler Replacement Project - Torque Values Needed
Comments: To: JRodgers <jrodgers113@gmail.com>
Content-Type: text/plain; charset="utf-8"

Make them tight. After a few heat and cool cycles tighten again. These bolts are easy to cut with a cut off wheel so not a big deal to use regular stuff. Loc tire is a good choice instead of antisieze.

Dennis,
From my phone.
________________________________
From: JRodgers<mailto:jrodgers113@gmail.com>
Sent: ‎8/‎17/‎2013 9:18 AM
To: Dennis Haynes<mailto:d23haynes57@hotmail.com>
Cc: vanagon@GERRY.VANAGON.COM<mailto:vanagon@GERRY.VANAGON.COM>
Subject: Re: Muffler Replacement Project - Torque Values Needed

Dennis, thanks.

I forgot to mention this is on an '88GL 2.1L engine.

I want to use stainless bolts with copper lock nuts at this connection
but had to order them  through a Nuts and Bolt specialty house. In the
meantime - I'm putting in regular bolts and nuts - lock washer under the
nut and spring washers under the head. The old bolts were standard with
common nuts on them. They were badly corroded and rusted and I was
surprised they didn't break when removed. The nuts actually turned.

John

On 8/17/2013 7:32 AM, Dennis Haynes wrote:
> What type bolts are using? Regular or the copper locknuts. This is a
> connection that likes to come loose. From the factor these bolts were long
> and a series of spring washer were used to allow for the expansion and this
> type of connection is designed to move slightly when needed. Other vehicles
> used shoulder bolts and actual springs on these joints.  Anyway, if using
> regular bolts, lubed go for about 14 lb./ft.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
> JRodgers
> Sent: Saturday, August 17, 2013 12:39 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Muffler Replacement Project - Torque Values Needed
>
> Having never found my Bentley after moving - I am a bit handicapped on
> certain Vanagon things.
>
> I am replacing the three bolts that hold the J-pipe to the cast iron
> Y-manifold and just need the torque values for those bolts. These were burnt
> to a crisp and I'm putting in new ones.  This is where the metal "donut"
> gasket goes in the exhaust system.
>
> Anyone?
>
> Thanks,
>
> John
>
> .
>